Download Printable 910B Product Sheet
The leader in remote controlled trailer diagnostic and repair equipment.
Presenting an electronic HD trailer electrical, air brake, and ABS inspection tester that is quick, reliable, and durable from LITE CHECK, the leader in technician-friendly fleet test equipment.
For over 15 years the INSPECTOR 910B has been working along side technicians battling ABS faults. The INSPECTOR 910B provides one touch identification and fault display for Bendix, Haldex, and Meritor systems.
Add LITE-CHECK’s INSPECTOR 910B to your arsenal of tools. It’s the high value, consistent, quick and easy HD trailer inspection tool.
The full function remote control lets a single technician preform every test without a tractor! This helps to keep maintenance costs low, and keep your fleet on the road faster and more efficiently.
If CSA and DOT inspections are affecting your fleet records implement the INSPECTOR 910B and clean up your scores. When you need a light, brake, and ABS test, you need LITE-CHECK!
No tractor required. One technician operation.
Trailer ABS Solutions.
Full function remote control.
Inspector 910B Features
SAFEGUARDS: Firmware embedded
- Reversed polarity protection
- Shut down with high amperage and low voltage
- Anti-compound prevention locks out service air until emergency air is applied
- Intelligent messages
- Display circuit voltage and amperage with condition
- Automatic fault alarm for circuit faults
- Full function remote control operation to verify lamp operation
- Auto circuit test
- Perform TMC Recommended Practice 141 (total trailer amperage load)
TRAILER AIR BRAKE OPERATION (with remote control)
- Regulated emergency air application (incoming air supply normally set at 110psi)
- Regulated service air application (internal air set at 90psi)
- Air system leak down test
TRAILER ABS/PLC OPERATION
- Automatic ECU identification and display of PLC fault codes after 2001
- BENDIX,HALDEX,MERITOR-WABCO
- Blink code support for prior 2001 MERITOR-WABCO and WABASH ABS
- Displays trailer mileage on PLC models
TRACTOR OPERATION
- Display tractor electrical pin output
- Perform TMC Recommended Practice 137 (tractor output voltage)
- Operate truck service brakes with brake actuator and remote control
VEHICLE CABLE TEST
- Automatic displays PASS or FAIL with cable test
- Identifies crossed-wires, shorts, and opens
REQUIREMENTS:
- Power: regulated filtered 12vdc (battery not battery charger) or LITE-CHECK POWER SUPPLY 311R
- Air: regulated filtered shop or truck compressed air supply of 120psi
